Hi all!
I have multiple drill-through definitions in a Cube and when I right click one of the metrics in the Cube and select the Go To option I get a list of all the DT definitions I created. I would like the metric to make a drill-through directly to the target report instead of showing the list of Available Links. I tried setting the Scope of each DT definitions but the Available Links page always shows up. Any ideas on how to drill through directly to the target report without selecting a DT definition from the Available Links page?
Thank you in advance. Have a nice weekend!
I always have an option to see the list of Available links, even with just one DT target. However, after right-clicking if there is only one option you can left-click "Go To" and it will go to the report without the intermediate popup.
If you are setting the scope of the DT to a value that does not appear anywhere on the source report, it should be filtered out. If it is not, I would open a support ticket with IBM.
Thank you for your reply!